Ricoh

Camera Overview

Supported models: SC2 (for business), X, V and Z1

The back of the camera is indicated by the small WiFi screen.
One side of the camera has 4 buttons:
- Top button — power button.
- The second button — Wi-Fi button (used when pairing with your device or to refresh the connection).
- We do not use the bottom two buttons.

Press the power button. The button will light up and icons will display on the Wi-Fi screen (if the Wi-Fi signal is flashing, it indicates the camera is NOT connected to your device).
Go to the Wi-Fi settings on your device and look for the Wi-Fi hotspot for the camera.
Click on the hotspot that begins with "THETA."
The password will be the 8-digit serial number that follows the letters ("YP" in the screenshot below) after the Wi-Fi name:

The password can be confirmed by looking at the bottom of the camera:

Once the connection is established between the camera and your device, the WiFi signal on the camera should remain solid.
Your device is going to indicate there is no internet connection. This is fine. This is merely pairing your camera with your device.
Camera is NOT connected to the internet. The camera and device have a connection.
Your device may be indicating it cannot connect to the camera. This error message can be ignored.
Note that only one device can pair with the camera at a time.

The next time you turn your camera on, it will automatically pair with your device (there is no need to enter your password every time).

Note: If you get a new device or reinstall the DocuSketch app, you will need to follow this process again.